Questions & Answers for: ic fuse

Question about PT-51G44 51" Rear Projection Television

Convergence

...ic fails the fuse goes also. the fuse or fuses can be near the ic, or can be located also in the power supply. I have seen that most times the fuse does not look like your normal fuse. they call them ...

Question about WS-65809 65" Rear Projection Television

1 Answer

ICS

...fuse for up to 10 seconds to make sure it stays on 0. the ic's are flat and sit up vertically on the heat sync. if your confused and dont want to try it, then i would recomend you get a local service ...

Question about WS-65809 65" Rear Projection Television

1 Answer

RCA model P61950

fuse had blown, or the pico fuses at the base of the STK convergence ics had blown, the STKs must be replaced. There is need of purchasing the service manual to do the job. The repair shuld be done by

Question about KDS-50A2000 50" HDTV

1 Answer

Power led lights blink 9 times, no power to

...good TV Tech and tell him about a Sony Recall on this TV concerning the S2 Thermal IC and Fuse.This causes the 9 blinks.It is an error code. S2 Thermal sensor IC and fuse S2 Thermal sensor IC and ...

Question about WS-65807 65" Rear Projection Television

1 Answer

Where is the fuse located for the convergence IC for ws65807

...IC for ws65807 where is the fuse located for the convergence IC There are two 5 amp pico fuses on the same board as the IC the board location jmbers are f(A04 and F9A05 they are solid green and look ...

Question about WS-65807 65" Rear Projection Television

1 Answer

Sp 55w3hf Convergence

sp 55w3hf Convergence I have a Samsung Projection TV sp 55w3hf and have replaced 2 IC's. I am able to line up the blue and green lines, but not the red. The red lines do not move at all. Question: are

Question about WS-65807 65" Rear Projection Television

1 Answer

I have a sony kp-65w600 i have changed boyh ics

...voltage to the ics There are 2 protection fuses on the +/- 19v supply line. On the G board, check PS6503, PS6504. These are 5 amp IC fuse links, PN: 1-533-597-31. I hope this helps, best

Question about KP-57WS500 57" Rear Projection Television

1 Answer

Convergence is off

convergence is off Check the pico fuses in front and behind the Convergences ICs STK392-110 Pico Fuses Look like resistors ,but they will be Yellow or Green 5amp -7amp fuses. If they are Ok then you ...

Question about KP-57WS510 57" Rear Projection HDTV

1 Answer

Convergence problem

...IC goes bad or the fuse going to the convergence ic goes bad. Pico fuses they are called sometimes open up. You may want to open it up and pull the board out and check the solder connections on the ...

Question about KP-46WT510 46" Rear Projection HDTV

1 Answer

My sony hdtv the picture

my sony hdtv the picture is like a3d effect with red tint flash focus will not work the crosses wont line up any solution or is tv shot? Replace your Convergence ICs they are Big Black ICs and will ...