Questions & Answers for: ide stand for

...ide connector for a hard drive, and guess what it turns on, but when you connect the ribbon just goes back to stand by mode, maybe requires a flash on one of the little chips, same thing happen to a ...

...stand alone. Any help is appreciated. Could have something to do with the IDE being set to master.. It has been known that sometimes the SATA drive will take over as the master.. Try changing the IDE ...

gigabyte ga-8i915p duo motherboard ide problems i just replaced my motherboard with a gigabyte ga-8i915p duo motherboard. my problem is i can't get the ide 2 and ide 3 raid controlled connectors to ...

...stand that no jumper setting required for SATA hard drive . now on my dvd which is still use IDE , set jumper as master , it reads alright as IDXE master and it show my SATA hard drive ...try to ...

...stand for Cable Select, Slave, and Master. They are found on IDE drives as the jumper points. Depending on where the drive is connected on an IDE cable, the jumper should match accordingly. CS is ...

...info on its SATA in RAID config.   In the bios there's an option to configure SATA as "IDE", "AHCI", or "RAID".If you don't have data to loose, try this. Install the drive, set the ...

what is stand alone jumper setting ? For IDE/PATA hard drives set the jumper to MA (master drive).

hdd wich hdd can I use in this computer? What is your computer, make/model would be useful. If a laptop 2.5" SATA. If a stand alone 5.25" ATA or IDE, can't say without knowledge of motherboard.

p4m800-m7 motherboard does not detect the wd hardisk 160gb harddisk maybe necessary to set single drive by 2 jumper settings. if IDE cable is used and its standing alone.

...IDE base, some have three or more. Install: Wood floor is best to stand on. Worst: Carpet adds static potential! Static can destroy your components inside your computer. Make sure to grab a hold of ...