dodge durango motor revs when sitting still,surgeswhen driven If there is no check eng lamp and no stored codes it could b the idle air control valve or coolant level or sensor
Idle air control system malfunction. Replaced the pcv valve and the idle air control valve but it is still doing the same thing, check engine light is also back on. does yurs have the idle air control
idle air control) motor & cleaning it good with throttle body cleaner , as well as port it came out of . These quite often get gummed up at pintle of motor (pointed part) and shaft, which cause it
...IDLE AIR CONTROL MOTOR CIRCUIT. P2781 AND PO1757 DID NOT SEE THEM IN CODE MANUAL.CODE PO505 WHAT ITS TELLING YOU.THAT YOUR STEPPER MOTOR COIL CIRCUIT IS SHORTED TO SYSTEM POWER B+ OR STEPPER MOTOR ...
...idle air control motor The idle speed motor is attached to the side of the throttle body. The throttle body is the piece that the air ducting connects to at the top center of the engine. There are a ...
...idle air control motor. You should also see the tip of the pintle of the IAC. Use a screw driver and carefully push/pry the pintle back into the throttle body. If the vehicle starts and idles than ...
...IDLE AIR CONTROL MOTOR CIRCUITS When Monitored and Set Condition: P0505-IDLE AIR CONTROL MOTOR CIRCUITS When Monitored: At power-up and battery voltage greater than 11.5 volts. Set Condition: The PCM ...
have problem from PO505 CODE P0505= Idle Air Control Motor
...Idle Air Control (IAC) system consists of a stepper motor and pintle. It is mounted to the throttle body and regulates the amount of air bypassing the throttle plate. Fig. MAP sensor, TPS and IAC ...
...Air control valve or the throttle position sensor You may want to clean or replace your idle control module called the IAC which is mounted to your throttle body. This is a stepper motor which ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions