Questions & Answers for: Acura where is the idle control valve

Question about 1997 CL

1 Answer

...Idle air control valve) If this valve gets clogged up with carbon it will cause a idle surge on cold starts like you are describing. Next your FITV (fast idle thermal valve). When the hot wax inside ...

Ad

Question about 1996 TL Series

1 Answer

...idle control system malfunction anybody know how to repair this problem for a 1996 acura TL Take the Idle Air Control valve off the bottom of the Throttle Body and clean it. If that doesn't work you ...

Ad

idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get

...idle control valve is either blocked or damaged this controls engine at low revs or idle, removing the pcv is just letting more air into the fuel system, but this will not be controlled airflow. this ...

Question about 1991 Integra Hatchback

2 Answers

idle higher than normal (supposed to be above 1K RPM for warming up). As the coolant warms up the valve closes and no longer lets air in through the hole in the throttle body. From this point the IACV

...idle air control valve, does it start if you step on gas pedal, and when it starts does it idle up and down and stall sometimes if so then replace that valve, good luck. Probably an old, weak

...idle air control valve. The valve may be bad or possibly the wiring. If it's the wiring, normally the computer will turn on the engine light. You can check the valve operation using a common obd2 ...

Question about 1991 Legend

1 Answer

...the idles too high it idles too high how can i fix that When was it serviced last? Or maybe its the idle control valve,ifit is that you might get away with just cleaning it up could be all gunked ...

the idle air control device-maybe clogged with deposits. The engine computer controls idle speed through this valve or motor. By increasing or decreasing the amount of air let into the intake manifold

...engine light and emission light on code p1005 Code p1005 means, the Manifold Tunning Valve Controll is out of the calibrated range. Remove and Clean the Idle Controll Valve it will fix the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Acura TL
1999 Acura TL

415 Questions

2000 Acura TL
2000 Acura TL

424 Questions

1997 Acura CL
1997 Acura CL

419 Questions

1991 Acura Legend
1991 Acura Legend

283 Questions

Top Acura Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...