Questions & Answers for: idle mix

...mix than normal), during start up conditions, and then as the engine warms, it should idle down to normal. Have you allowed it to continue its fast idle to see if it idles back down? Your post ...

mix screw until it will idle un-added with the throttle then adjust the idle on the throttle to get a good idle speed. Next adjust the High fuel/air mix until it gets the RPM's you want it to have. It

mix screw until it will idle un-added with the throttle then adjust the idle on the throttle to get a good idle speed. Next adjust the High fuel/air mix until it gets the RPM's you want it to have. It

...mix. adj. idle speed or mix. idle speed then sync. or idle sync., mix. How should I proceed? FIRST, YOU DIDN'T NEED TO REJET THE CARBS. I WOULD PUT THE STOCK JETS BACK IN IT WILL RUN JUST FINE. YOU ...

...idle air mix screws, this only adjust the idle mix, not the fuel ratio when running above idle, I have seen slots (screw driver) oval, hex screws, your going to have to see which one you have, take ...

2010 Malibu LTZ rough idle Just bought certified used 2010 Malibu LTZ. Idles rough at stop as well as coasting. Of course it's intermittant and no pattern to when it happens. Had it in and they ...

on full load then check spark plug again. dont mix up the idle screw with the mix screw. should have a white film on idle speed and a slight red colour or full load. run for 10min at a time then check

...idle mix screw and an idle speed screw. There may also be a high-speed mix screw. Try turning the idle speed screw in 1/4-turn at a time until it idles. If you turn it too far, the clutch will always ...

idle mix adjustment. With the engine warmed up & idling, turn that screw in (clockwise) 1/4 turn at a time until you can hear the idle speed drop a little. Back it out 1/4 turn and leave it alone.

low speed mix 1/8 turn and readjust high speed mix. If saw doesn't fire in 3 or 4 pulls remove plug. If plug is dry no fuel, if wet either no spark or idle mix to rich (or fuel metering may be fouled)