1992 chevy pu. 4 wheel drive electrical issue. truck would start only after turning ignition switch several times, then all red ignition lights on dash went out. now it does nothing when switch is ...
how do I replace the ignition switch on a 1999 chevrolet suburban? After the key is placed in the ignition switch, the key becomes very hard to turn and activiate the starter. I ''jiggle'' the key, ...
...the ECM fuse and then check for any loose wire connectors, especially at the fire-wall area, the ignition coil, and the distributor. Then check for battery voltage at the positive side of the ...
got fuel to the throttle body but still wont fire, There is the possibility that the ignition coil is faulty and first check to see if full battery voltage is getting to the "Pos" (+) positive side of
wheres the ignition module located want to remove ignition module The ignition module is inside the distributor.
...center under the hood all fuses good but.. The ECM-1 and the ENG-1 both read under 1 volt with the ignition on. Does this mean the ECM is shot or is the ignition switch?? Solved by OP. Further ...
ignition switch what is the starting button called in the ignition? Ignition switch.
TRANSMISSION SPEEDOMETER DOESNT WORK Fuse # 20 or 21 gets power through ignition. This fuse controls PRNDL indicator, speedometer, tach, & will cause transmission to not shift gears correctly. ...
Question about 1995 K1500
Ignition fuse blew a couple times one day. 3 time it was just D.O.A. no fuse helped. The third fuse I put in the ignition fuse spot didn't blow, but it also didn't start. After awhile of trying to ...
...chevy astrovan mil inspection failure We had this same problem with a 1997 Z71. After putting 3 ignition switches in it in 6 months, We finally figured out that every time we used the 4 wheel Low ...
Usually answered in minutes!
878 Questions
795 Questions
754 Questions
575 Questions
561 Questions
