Question about 2001 Venture
...ignition module if i do decide to change it. I am gettimg some sputtering specially on start up JUST ASKING TO SEE IF 3.4L ENGINE ON MY 2001 CHEV VENTURE HAS AN IGNITION MODULE THAT CAN BE REPLACED. ...
...ignition module got a buick le sabre, '92. need info on installing a ignition module Unscrew the ignition coil(s) from on top of the module...(leave plug wires attached)....and set aside noting coil ...
...ignition module doesn't have TH, F1, F2 My new ignition module doesn't have TH, F1, F2 and 24VAC plugging sites so the pertinent wires are not connected anywhere. Is this ok? no, the replacement ...
...ignition module burning out is because of the ignition coil, and you should try replacing the ignition coil and the ignition module both together, and be sure to clean out the distributor mounting ...
...ignition module located on the side of the distributor, and you can remove the ignition module (requires a special tool available from most auto part stores) and most auto part stores will test the ...
...ignition module or pick-up coil/stator inside of the distributor, a faulty ignition coil, or the ECM/ECC (Engine Control Module)/(Engine Control Computer) it will be called one of the two. The ...
Question about 1996 Blazer
...ignition module fail 5 times in the past year.It only happens when i go to start my car.What might be the problem? If this concern is encountered, inspect circuits 406 (IC Control for 2/3 Coil) and ...
Question about 1992 Suburban
...ignition module or pickup coil. The module is easier to replace - but the pickup coil is a wear item and the most likely fault. You could replace the module first and see if it starts or just replace ...
ignition module.Check ignition module is functioning. (remove earth wire from ignition module, this should make sure the ignition module sends current to the spark plug and not to ground)Check spacing
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions