...ignition switch. The car will stall one day and the next day will start. It has been replaced once with one from a junkyard. Was there a problem with the original switch? sometimes my 1996 ford probe ...
...the battery and still nothing that car should have several fusible links usually coming off battery, starter switch, or starter solenoid... also make sure you are getting power to the ignition ...
has no spark not getting 12 volts to tfi or coil these have a problem with the ignition starter switch, replace it.
...have you replaced the ignition switch? not the key cylinder but the actual electrical switch, they are prone to this type of failure, pull the covers off the steering column and test the
...ignition switch illumination bulb and remove the cluster module. Loosen the 2 cover hinge screws and the 6 upper cluster cover screws. Remove the cover. Remove the lower cluster cover panel. Remove ...
...ignition switch and pull it straight off.Disconnect the ignition switch lower harness connector. This is just below the steering column or can be seen at the opposite end of the ignition ...
...switch, check ingnition coil - ok , spark in # 1 spark plug , check all fuses - ok , fuel relay i dont have any idea how to check it, and also on fuel pump test. Check for fuel pressure on the fuel ...
...Ignition Switch Lock Cylinder Removal Remove the steering wheel (3600). Refer to the procedure in this section. Remove the four lower steering column shroud screws. Separate the upper and lower ...
...ignition switch if not ignition switch could be bad or could have blowed ignitrion fuse.if every thing check out good so far.do a tune up replace spark plugs, rotor and distributor cap check ignition ...
...probe tach quits working and then runs like crap then wont start now whats the problem? Might try checking the wires on the back of ignition switch? I was having that prob that was were it was for
Usually answered in minutes!
235 Questions
215 Questions
166 Questions
158 Questions
87 Questions