Questions & Answers for: Chevrolet ignition wires

Question about 1987 G10

1 Answer

...ignition key assembly 2.) There should be 5 to 8 wires there 3.) Locate 2 wires of similar color 4.) strip these wires and tie then together this will turn on the ignition 5.) find the starter wire ...

Ad

Question about 1996 Caprice Classic

1 Answer

...ignition,There are 2 wires comming out of the side case and I am trying to figure out how wire up the basic ignition to get it to run.Thanks JB On Dyna S DS6-1 Dual Fire Ignition Systems The WHITE ...

Ad

...ignition switch-what wires to check power on 1996 ignition switch-what wires to check power incoming power on no responce from ignition.( power @starter,power@alternater) ignition switch may be worn ...

Question about 1999 S-10 Pickup

1 Answer

...then reconnect them.But to figure it out the problem is only in the ignition switch and its wires or wire connections.You just have to repair and reconnect the wires and repair the ignition

...wires to the ignition coil. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab. If replacing only one plug wire, open the retaining clips and install ...

Question about 2006 Venture

1 Answer

need to replace ignition switch Ignition Switch (2005 Chevrolet Venture listed but the 2006 Venture was not) Removal & Installation To Remove: Before servicing the vehicle, refer to the ...

Question about 1996 Cavalier

1 Answer

...and connect one side the a ground somewhere then check all the wires with ignition key off. when you find a wire with power then mark it and turn on the ignition and look for the ignition power

...ignition switch has 5 wires, 3 (yellow)(orange&black striped) and (red&white striped)run together from the top of the ignition switch to one corner of a metal box just under the ignition switch. The ...

...that face firewall. Factory Anti-Theft Wire: Yellow (+) and Black (-) and White (Not Used) Factory Anti-Theft Wire Location: GM Passlock 2 System (Wires Are At The Top Of The Ignition Switch

Question about 2001 Monte Carlo

1 Answer

How to change a coil pack on a Chevy Tahoe To Remove...... 1. Remove the spark plug wire from the ignition coil. 2. Disconnect the ignition coil electrical connector. 3. Remove ignition coil bolts. 4.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...