Questions & Answers for: John Deere ignition wires

...next next. We will be testing for voltage to the points, coil, engine to tractor wiring harness, ignition switch Tools needed: volt meter to read 12 volts, or test light 1) with the points open:

JUST REBUILT ENGINE, PUT ELECTRONIC IGNITION AND NEW COIL IN WONT START SHOULD THE COIL BE GROUNDED TO SOMETHING? SHOULD NEG WIRE ON IGNITION BE WIRED TO COIL, OR FRAME? Only the frame of the coil ...

...wires with the ignition on & off. The three yellow wires were the hot ones. There are 2 together & 1 alone. I spliced into one of the 2 that are together. The one that is alone is for the ...

john deere 110 engine cranks but no spark Check that the ignition coil kill wire is not shorted to the frame. Check coil to flywheel gap. A business card between coil and flywheel will set correct gap

JohnDeere 524 snow blower the wire from the ignition switch The wire from the ignition switch broke off from where it was attached to can anyone tell where this wire attaches to on the other end it is

...ignition modules YLW/WHT wires. If not battery voltage, the ignition relay, for what ever reason, is not providing power to the coils. See following link for wiring diagram. ...

...ignition switch, so it should have 12v whenever the battery is connected. Sounds like you have a shorted wire somewhere. Look for burnt insulation along wiring loom, especially where wires might be ...

...Ignition switch is good, new battery, new starter solenoid, new starter, all wires and connection points are clean. When I turn the key, the only sound is the click of the starter solenoid...what ...

...not turn over, with the ground wire connected to coil motor turn over no spark except when release ignition switch only one spark. Is this the ignition switch I can remove ground wire and jump

...wires that connect to the ignition switch M (magneto) pole. When the switch is in the off position the kill circuit connects to battery negative. The safety circuit effects a similar connection to ...