Questions & Answers for: Chevrolet Venture ignition wires

Question about Chevrolet Venture

1 Answer

...To bypass a constant just run a wire from the battery to the stereo. You can also run it from the ignition constant. I would recomend a wiring diagram. You can get a manual for almost any repair ...

Ad

Question about Chevrolet Venture

1 Answer

...ignition switch and wires in main harness fuel parts still that could be a issue fuel pump fuel lines injectors carborator or .throttle body ecm injectors and all smog related components feel free to ...

Ad

...ignition module but it most likely don't need to be replaced unless there is no power to the spake plugs. Most common tune up will be the spark plug and wire set. the three front plugs will be ...

Question about 1997 Venture

1 Answer

...Replace the One Wire connection to that One Spark Plug. Replace that One Wire connection to the Ignition Coil. Go onto the next Spark Plug using the above Rules. Repeat. For the 3.4L V6: Firing ...

...battery....lights and radio work nothing happens when turn the key. Starter Fuse? Possible failed ignition switch. Loose Cables on battery or starter. Starter not grounding properly. Bad starter ...

Question about 2006 Venture

1 Answer

need to replace ignition switch Ignition Switch (2005 Chevrolet Venture listed but the 2006 Venture was not) Removal & Installation To Remove: Before servicing the vehicle, refer to the ...

...wires for proper orientation. With the ignition OFF, remove the fuel pump relay. Crank the engine and test for a strong spark on each cylinder spark plug wire using a suitable spark plug tester. ...

Question about 2002 Venture Passanger

1 Answer

...Ignition (1) voltage • Ground When it stalls check for spark , pull spark plug wires off the same coil an crank the engine . Is thier spark jumping from one coil tower to the other ? Make sure it's a ...

...wires are not touching the exhaust then replace the sensor with a genuine one as the settings may be different on an after market one giving a false code .Code p0300 refers to random / multiple ...

...wires or ignition system. see if you have power to starter by testing the wire. Sounds like no click on start=no power to starter. The starting system uses a "chip" or coded key to communicate with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...