Questions & Answers for: Ford Explorer ignition wires

Question about 1997 Explorer AWD

1 Answer

key for ignition we are trying to get a key made for our 1997 ford explorer ignition..we are unable to remove the ignition switch to take it in...we tried a door lock but they said it wouldnt work for

Ad

how do I replace the ignition switch in my 1992 explorer hi, Remove the steering column cover. There should be four screws. This will give you access to the column and the switch located behind the ...

Ad

Question about 1998 Explorer

1 Answer

...wires hooked to it but also a little wire from the ignition switch. If you dont hear a click then either the ignition switch is bad or the solenoid is bad. Or perhaps the contact from the ignition at ...

Question about 1996 Explorer

1 Answer

...WIRES, THEN THE COIL PACK AND LAST THE FUEL INJECTOR BUT PROBLEM STILL THERE, ANY HELP WOULD BE GREAT OK, Have you tried the following: Ignition Control Module (ICM) REMOVAL & INSTALLATION NOTE: ...

...ignition components (coil, wires and plugs) - Low battery charge - Powertrain Control Module Possible Solutions: - Resecure loose wire or connectors - If battery charge is low, recharge or replaced ...

Question about 2004 Explorer

1 Answer

...wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes in your book to reflect ...

Question about 2004 Explorer

3 Answers

...the rubber boot.After removing the lower shroud under the steering column, you have to turn the ignition switch to on , then push in the retainer ball under the ignition housing to remove the ...

Question about 2004 Explorer

1 Answer

wires can come lose and your ignition wire could be touching ground.  Ignition wire in the explorer should be Pink and/or Pink/white. If you've had any aftermarket components installed in the

show me what the ignition module look like and show me where it is located see the spark plug wires. follow the wire center they will go to the coil primary. this is the ignition module.God bless you

ignition wires after attempt theft my ignition is damaged and wires i stripped and reattached all the wires to correct harnesses with the exception of one white/black one black one yellow one red {all

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

Manuals & User Guides

Loading...