Questions & Answers for: Kia Sorento ignition wires

...wires function it makes it easier to join to after maket key.To get vehicle to run join 12v to ignition/coil wire and touch starter wire to 12v until running then remove.When stopped do not leave 12v ...

...with those from another convenient cylinder (#2?). Does the #3 still miss? If so, it could be the ignition coil. Does #2 (the swapped one) miss? If so, gap the plug or replace and /or replace

...installing a remote car starter for a 2003 4x4 kia sorento 12 VOLT CONSTANTGREEN (+) and BLUE (+) IGNITION SWITCH HARNESS STARTERRED (+) IGNITION SWITCH HARNESS STARTER 2N/A IGNITION 1YELLOW ...

2004 kia sorento after ignition wires replace vehicle won't start,also one coil was replace. no power going into fuel pump wires are crossed and check fuel pump fuse and relay

...sorento 2004 Sounds like a shorted wire.. This is from a Kia forum on the subject: The ECM computes ignition timing in response to the signals from several sensors. The timing is fixed during the ...

...ignition wires: disconnect ignition coil harness connectors disconnect ignition wires from ignition coils remove hold down bolts from ignition coils while gently twisting pull up and remove ignition ...

2005 Kia Sorento doors lock with keys in ignition Before I had the car worked on, the vehicle would not lock if the keys are in the ignition. Now it does. Is there a program that has to be done so ...

...cover is usally held on by about 4 small bolts. remove those bolts and you'll see a series of 4 ignition coils with wire connectors. Disconnect those wire connectors and remove the coils being ...

...wires onto high pressure pump. One wire is ignition live. It's the second wire I can't work out. Should it be an earth? Trying to figure if sensor is faulty Thanks in advance for any ...

...ignition on without starting the engine. If there is no movement on the fuel gage problem is in the sending unit if there is Some move the problems is going to be a faulty wire. If it is is a faulty ...