...inlet/outlet filter Outlet filter is located behind the little square door at the bottom of the machine. The inlet filter is in the end of the inlet hose. It is also a filter in the valve on the ...
...inlet and outlet? Most newer units have a brass inlet on the valve and a plastic outlet. Older modles have a plastic garder hose type fitting for inlet and same smaller plastic thread for outlet Some ...
...inlet hose clip to the outlet duct. 17. Tighten the air cleaner outlet duct clamps at these locations: Throttle body MAF/IAT sensor Tighten the clamps to 7 Nm (62 inch lbs.). 18. Fill the cooling ...
Question about Automatic Salt Water System for Above Ground Saltwater Pool
...inlet and outlet openings so that you can do the next stepsAssuming you have checked your outlet for blockage (skimmer, screen, etc.) take the hose off the end of the chlorinator (goes to the pool ...
Question about Automatic Salt Water System for Above Ground Saltwater Pool
...Thermostat Water outlet Water outlet bolts and tighten the bolts, Torque to: 22 ft-lbs (30 Nm) Inlet hose to the water outlet Fill the cooling system. Test drive the vehicle to confirm the
Question about Automatic Salt Water System for Above Ground Saltwater Pool
...inlet or outlet ? The other spot has a H for hot is that a inlet or outlet ? And the other one is not marked what is that one for and is it a inlet or outlet ? please email me at [email protected] My ...
...Thermostat Water outlet Water outlet bolts and tighten the bolts. Torque to: 22 ft-lbs (30 Nm) Inlet hose to the water outlet Fill the cooling system. Test drive the vehicle to confirm the
...inlet hose clip to the outlet duct. Tighten the air cleaner outlet duct clamps at the following locations: Throttle body Mass airflow/intake air temperature (MAF/IAT) sensor Tighten the air cleaner ...
Question about 2011 Scorpio
outlet or the inlet I know the tappet clearance for the inlet valve is 0.30 mm, while for the outlet valve it is 0.45mm, as mentioned in the owners manual. What is not clear however is, which valve is
...there is a joint you will find o-rings. Inlet and outlet of condenser, inlet and outlet of compressor, inlet and outlet of evaporator core, and inlet and outlet of accumulator. That is all you
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
