Questions & Answers for: Chevrolet Blazer install filter

Question about 1999 Blazer

3 Answers

...gas line the size of a spark plug, i had same problem. You will want to check the fuel filter you installed to make sure that it is installed correctly. Most of the replacements are a one way

Ad

Question about 1992 S-10 Blazer

1 Answer

where is the oil filter located Unless an aftermarket filter is installed, there are no oil filter lines. The filter is mounted on the engine block at the right rear of the engine on a special ...

Ad

...connection to the tank and install a new fuel filter. Before reinstalling the fuel tank I would install a new fuel pump to save problems later. By the way dropping the tank is not a difficult

...frame rails. Your old fule filter only has 2 retainers to loosen, remove and install new one.Make sure you have a pan or something to catch the gas that spills when you remove filter. Hope this ...

Install the two vent valve pipe clips into the existing underbody holes. Connect the vent valve pipe to the EVAP canister. Connect the EVAP canister vent valve electrical connector. Lower the vehicle.

Question about 2001 Blazer

2 Answers

...filter (Q) Regulator seal O-ring (R) Install or connect the following: Fuel pressure regulator with the vacuum tube pointing down Fuel pressure regulator retainer clip (M) Upper manifold Test drive ...

...install the oil filter adapter. If removed, install the oil filter. If equipped with automatic transmission, install the converter housing pan and the transmission oil cooler line retainer to the ...

Question about 1989 S-10 Blazer

1 Answer

...up.when you replace the oil filter,use a thin film of oil around the oil filter gasket before you install it. you'll find that it helps to seal the oil filter perfect.thank you for choosing ...

Question about 1994 S-10 Blazer

2 Answers

filter to the vehicle. Install or connect the following: Filter to its bracket finger-tight New gaskets and connect the high pressure hose and eye bolt, then the main pipe. Tighten the eye bolts to 22

Question about 2000 Blazer

1 Answer

...filter To install: Install or connect the following: NOTE The filter has an arrow (fuel flow direction) on the side of the case, be sure to install it correctly in the system, the with arrow facing ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...