...washer reservoir by sliding it out of the side slots. Remove the windshield washer pump. Installation To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87
...windshield washer on 1997 saab 900s Location of windshield washer pump on 1997 saab 900s you know where the windshield washer fluid tank is ? if so remove it the windshield washer pump is located at ...
...windshield wipers do not work and I checked the fuse #37 and the relay #11 and they still do not work, I think it may be the motor....the washer fluid does not spray either can it be something else? ...
...my headlamp high-pressure washers are not working. Any ideas? I have a 2007 Saab 9-7x 5.3i Matt there are two washer pumps in the washer fluid tank. The pump for the headlamp washers may be
windshield washer fluid resovoir I have noticed that my windshield washer fluid resovoir is leaking, but I cannot tell from where. How do I remove the resovoir so that I can make the necessary repairs
windshield washer fluid not spraying Three possibilities immediately come to mind: is there any fluid in the washer reservoir? can you hear the spray motor running? are the spray nozzles connected ...
Question about 2005 9-3 2.0
Install the upper bolt followed by the lower bolt, and tighten to 5 Nm (44 lb-in). Disconnect the windshield washer tube assembly from the pump and release the windshield washer tube assembly from the
...windshield washer fluid Why Won't My Windshield Washer Work? - RepairPal repairpal.com > Car Care Advice > Troubleshooting Check the Fluid First, check that the windshield washer bottle has fluid and ...
...Windshield Washer Pump and System Diagnosis - YouTube ? 10:00 https://www.youtube.com/watch?v=0SdUhyQF4tY Sep 9, 2012 - Uploaded by RatchetsAnd Wrenches You'd think the pump would run continuously, ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions