Questions & Answers for: installing 5 7 head gasket

...head , Remove electrical connector (5) at top of EGR valve solenoid. Remove tube mounting bolt (1) at intake manifold. Remove two bolts (4) connecting EGR tube (1) to valve assembly. Remove gasket ...

...head isreplaced or re-installed to obtain proper torque. Foot pounds (Final torque) Note: Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: ...

head bolts 8-------1-----3-------5 6-------4-----2-------7 CYLINDER HEAD bolts are tightened in three progressive steps 1. 34 Nm ( 25 ft.lb) 2. 90 degree 3. another 90 degree. double check everythings

choose ring installation tool to the correct size for your pistons. 5) re-install head of engine (replacing head gasket) Note that this procedure preserves the engine timing, so you need not reset it

...5-cylinder, and 2.9L 6-cylinder engines have a two-piece cylinder head, the upper half and the lower half. The upper half is basically the same as a valve cover, except that it incorporates the ...

...head cover). 3. Remove the air-intake hose. 4. Remove the vacuum hose, fuel hose and coolant hose. 5. Remove the cables from the spark plugs. The cables should be removed by holding the boot portion. ...

...head , Remove electrical connector (5) at top of EGR valve solenoid. Remove tube mounting bolt (1) at intake manifold. Remove two bolts (4) connecting EGR tube (1) to valve assembly. Remove gasket ...

...Head ... Torque Specs 10 posts Jul 28, 2012 Valve cover torque specs 5 posts Jul 4, 2011 Timing Repair Project - Bolt Torque Specs 7 posts Jun 16, 2011 torque specs? 9 posts Mar 20, 2006 More results ...

...head bolts in sequence on the final pass. Tighten: Tighten the long bolts (1, 2, 5, 6, 9, 10, and 13) on the final pass in sequence to 75 degrees. Tighten the medium bolts (14 and 17) on the final ...

...5.9L Engines NOTE A steel-backed silicone gasket is used with the cylinder head cover. This gasket can be used again. 1. Disconnect the negative cable from the battery. 2. Disconnect closed ...