...IP and mac address to phone. Also static it on the same subnet.It will go through about three long reboots.If it doesn't work change the NBX to anything but "ethernet only" and reboot it. Then ...
...IP Phone, and it working good, no blank screen adn no reboots. The bandwith of our channel betwen offices 512 Kb/sec. The loading channel 20-30% I would verify what the firrmware is of the phone. It ...
Question about SoundPoint 330 IP Phone
...ip 330 sip phone. after that i rebooted once then its works perfectly with 2 lines. then again i reboot the phone then its not working. it displays that "can not contact to boot server" after that ...
Question about 5610 IP Phone
...phone a new IP adress now after it displays discover and the phone has rebooted it ask's to enter command is the phone now asking you to config from scratch? we try pressing the enter button but any ...
Question about 7940G IP Phone
IP Phone: how to solve the protocol application invalid prob... How to solve the protocol application invalid problem cisco 7940 Hi This happens when you IP phone communicated with the Voice vlan with
Question about SoundPoint IP 320 SIP IP Phone
...phone keeps trying to reboot itself. We rebooted manually a few times and get the same error message: 'Could not find boot server current configuation" Any ideas? try to turn off the Polycom device. ...
Question about 5610 IP Phone
...IP phone contractor sent a phone after activating the system at headquarters. They configured the remote phones and shipped them. They were supposed to work out of the box. They didn't. An IT ...
...Conflict * to program Reboot the phone to grab a new DHCP address. If it still does that, then something else has that IP, and the phone has a static as well, so teh phones IP will need to
Question about 7945G IP Phone
IP Phone 7945G keeps rebooting after I did a factory reset. Is there a way to fix this? I did a factory reset on this phone and not it is stuck in reboot mode. I have attempted to do the factory reset
...IP phone I brought it second hand thanks Reboot phone and hold down the down arrow key. This will put you in the programming of the phone. Use * and # to toggle thru until you see default . Then ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions