cage breaks free and allows the chassis legs to bang against each other. Put the car up on the side jacks, put a screww driver or jekky between the two chassis members and check for movement. If there
Question about 2003 Range Rover
...operation. To avoid damage occurring to the under body components of the vehicle the following jacking procedures must be adhered to. DO NOT POSITION JACKS OR AXLE STANDS UNDER THE FOLLOWING ...
...shaft ...did you visually look under the car for any obvious obstruction as well as check all the lug nuts on the tires ..last night someone loosened all my lug nuts to my front tire and replaced the ...
...jack up that side and remove the tire remove the brake caliper remove the lower control arm remove the lower ball joint out of the ball joint then force the shaft of the ball joint out of it,s socket ...
...jack once disconnected to let it down, but other than that it's not that bad of a job. Is it leaking from the output shaft seal? if so there are two / front and rear get the set with both and just do ...
...shaft Jack up car, support with stand, remove wheel and calliper/drum. Undo big hub nut (lots of force needed) and attempt to push the shaft backwards out of the hub. If you can't, disconnect any ...
Usually answered in minutes!
931 Questions
392 Questions
318 Questions
325 Questions
340 Questions