...transmission.by the cv shaft is a 1/4" plug or it takes a 7/16 socket.whith the car running and not jacked up pull the plug.if fluid runs out it is full. if no fluid leaks out it is low.the car must ...
Question about 2000 Grand Am GT
...jack stand under it. A tire lug to remove tire. A 36 mm socket to unbolt axle shaft sticking through bearing hub. Next a Brass hammer with a block of wood. Next center wood on axle shaft sticking ...
...transmission.by the cv shaft is a 1/4" plug or it takes a 7/16 socket.with the car running and not jacked up pull the plug.if fluid runs out it is full. if no fluid leaks out it is low.the car must ...
jack the car up evenly, and right under the passenger side cv shaft there is a small plug that you remove and slowly start filling the transmission until it starts to run out of the hole, then replace
...jack up the car and pull the rf wheel, you will see the cv(drive shaft) going to the transmission. just past where the shaft goes in, you should see a plug on the trans. unplug it, and it should be ...
...shaft nut then jack the car up and support it with jack stands and remove the tire. after you get the tire off you may have to remove the break caliper and the rotor, if you have to do this now. ...
...shaft support jack stand as you slide the new hub into place lining up the axle and the holes where the hub retaining bolts go (if you just shove it in, it can be impossible to turn it to line up the ...
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,208 Questions