rumbling noise at 30mph and above is it the cv joints? noise gets louder at freeway speed....do cv joints make noise when they are going out? How can I tell if the cv joints are bad????? sounds more ...
a different tpye of cracking noise when turning right. all the joints, arms,shocks, wheels, seem "tight". CV joint cracking noise when turning . Check you shock absorber by visual checking it for leak
joint. Not serious if noise level is low and can be used if you do not mind the noise. Check however if the booth (cover) of the joints are intact and are filled with lubricant. Replace as soon as you
...noise when sitting still at idle) CV joint boots are not leaking grease. Wheels / rims are not loose/wobbly when you jack the front tires off of ground. Noise is coming from the front of the vehicle. ...
Question about 2003 Cooper
...joint. Look under the car behind the wheel that the noise comes from and you will likely see a rubber grease boot over the joint that is torn or otherwise damage. the joint must be replace in most ...
...cracked driveshaft? A "CLICKING" NOISE WHEN TURNING USUALLY INDICATES A BAD CV JOINT. LOOK AT SIDE MAKING NOISE AT INNER AND OUTER CV RUBBER BOOTS...IF CRACKED OR TORN....PROBABLY NEED NEW CV ...
...joint noise, since you are not going over bumps. Also look at the CV rubber boots (2 each side) to find any splits in them. Those let grease out and dirt in, and rapidly end the life of a CV joint. ...
Question about 1998 Continental
...joint I believe is whats making the squeaking noise when turning the wheel left either stationary or when movi car makes rattle noise when going over tiny bumps at low speed. Also makes a loud ...
Question about 1998 Continental
...noise is there if it isn't then I would consider the joints in the axle shafts to be candidates for repair /replacement it all has to do with the torque wind up when in 4x4 and any worn or failing ...
...noise if not replaced with struts. Also check ball joint. It fills with rust under boot due to non greasable style ball joint. Must use large bar to inspect these ball joints, to be able to lift ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions