Questions & Answers for: ST 502 kawasaki spark plug gap

Question about kawasaki ST 502 Motorcycles

1 Answer

How do i change the altenator The alternator on your bike is not external. What you will probably end up changing is the rotor if the magnets are bad, or the stator, or both. The stator is the ...

Ad

Question about kawasaki ST 502 Motorcycles

1 Answer

how to remove battery Which motorcycle is this for? It is usually a simple operation, locate battery and disconnect the earth (-) then disconnect the positive(+) remove battery and replace in that ...

Ad

Question about 2007 Vulcan 900 Classic LT

1 Answer

how do drain and add fork oil on a 2007 kawasaki vulcan 900 classic? If you don't know by looking at the service/workshop manual, take it to a specialist suspension place. You could do more harm ...

Question about 2007 Vulcan 900 Classic LT

1 Answer

I have a 2006 Kawasaki Vulcan 900 . I somehow have, when replacing the seat , gotten the seat latch jammed. Now, turning the key does not release the seat latch and I cannot get the key out of the ...

My battery for my 2006 vulcan 900 cant start bike every time temp outside is 32 degrees or below. Need to jump start it. But starts normally if warm temperature. check battery connections to see if ...

Question about 2007 Vulcan 900 Classic LT

1 Answer

Why would my speedometer quit working sometimes? speedometer stops working? the cable could be lose or corroded and not getting proper contact

Question about 2009 Vulcan 900 Classic LT

1 Answer

what amperage should my when testing the charging system what apearage should be read It all depends, most bikes have a low amp rate for charging around the 1 to 1.5 A mark. What you need to check is ...

Question about 2008 Vulcan 900 Classic LT

1 Answer

...he car or motor factory needs, de order the tires they can get when the price is good. Ask your Kawasaki dealer, what a good tire is for your motor. Trust

I hear a grinding noise when i disengauge the clutch on my 2007 classic lt 900 You may need to adjust the clutch cable tension. If it is hydraulic, you may have a slave cylinder going bad. Either way,

Own a 2010 Vulcan 900 Cla. When the fuel gauge says empty it only takes 3.3 gal. to fill. Anyone know why and how I can make the gauge a little more accurate?. Thanks gang! - Ron from Kansas Own a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...