Questions & Answers for: kenwood stereo protect Audio Players & Recorders

...stereo by kenwood everytime i turn it on it says protect and just goes off your speaker output is shorting either at the output terminals or at the speaker input . check the cabling . it will solve ...

stereo will all this work on the kenwood model kdc-bt555u need to enter code notify dealer Press 3 + 6 and then connect supply Press 1 until OK appears on screen Press 2 Press 2 for 4 seconds until OK

...Kenwood Car Stereo. The KDC-MP238. While playing a CD I hit a large pot hole and the Radio went into ''Proteced'' Mode. It will no longer play CD's or the Radio. How do I get the radio out of ...

...code in so it went into secure mode it to prevent the device from working if stollen when i try to increase the volume on my Kenwood Stereo Receiver it goes into Auto Protect mode...how do i fix ...

...kenwood car stereo off of protect mode Look on the face plate for a really small hole. Put the tip of a pen in the hole and hold it for a few seconds. Your system should then re-set. If the Protect ...

kenwood car stereo cd player reads protect mode how do i fix this my kenwood cd player for my car is now reading in protect mode how do i fix this i have a kenwood kdc-241 car stereo and it has gone ...

...kenwood car stereo is in protect mode. Solution: Open the hood of your car or van, and disconect 1 battery wire, do-not let the battery wires touch, this will re-set the stereo back to normal, you do ...

kenwood stereo is going into protect mode, it is because one of ur speaker wires is shorting out. Make sure all of ur speaker wire connections are good, and then wrap them so they aren't grounding out

kenwood car stereo is flashing protect over and over was working perfectly then went into a store and when i started the vehicle the stereo is flashing protect over and over so nothing works. how do i

...Kenwood car stereo out of protect mode ? I bought a used Kenwood e232 car stereo, it's not hooked up , but when i conect the power wires it goes stright in to protect mode, i tried pushing the reset ...