...stuck. The knob that must be loosened to wind the bobbin is stuck Remove the needle, and place a screwdriver or something like it under the needle bar to keep the wheel from turning. Wrap the knob in ...
Question about 3537 Mechanical Sewing Machine
...stuck behind the knob. Don't force the knob. It's possible to take the motor casing off and work it loose. Use TriFlow lubricant (small black bottle Sherwin-Williams) and leave for a while. Push ...
Question about 3537 Mechanical Sewing Machine
...stuck around a knob on Necchi 536 FB sewing machine I have a Necchi 536 FB, probably 15 years old. Works well, except that thread gets really taught in the machine. It gets REALLY stuck where it's ...
...stuck and will not change. The knob moves but there is not change in the stitch length and it is stuck in size 0 stitches. Could the knob be stripped? Is there a way to remove the knob and change the ...
...knob appears to be stuck and the stitch picker eg zig zag etc moves but dosent seem to change anything. whats going on and how do i fix this? Warm up the area of the knob with a hair dryer to see if ...
Question about L-344 Mechanical Sewing Machine
...to see if it is stuck inside the knob. The washer is about 1" in diameter with a couple little tabs on it. It will only work when installed correctly so if at first you fail just turn the ******
...stuck and I can't turn towards me to use the "wind-bobbin" feature. There is a hole where it looks like a screw should be on the clutch, but no screw, so I don't know how to take it off. Any ideas? ...
Question about L-344 Mechanical Sewing Machine
...Knob gets stuck. How to make stitch length lower? SLIGHTLY unscrew the large screw in the center of the stitch length knob, turn the knob to the right several clicks and retighten the screw. DON'T ...
Question about L-344 Mechanical Sewing Machine
knob on bernina 600, not Deco, is stuck and cannot select needle position, However the width of stitch part of the knob is working.This knob has 2 parts, needle position and width control Your machine
Question about L-344 Mechanical Sewing Machine
Stitch selector knob and the reverse button are stuck but it will sew in reverse. The old oil has dried and caused it to seize. Wheel on right side that controls the needle up and down is very tight..
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions