Question about 2006 GPR 125 Racing
...125) The digital rev counter, centre dash does not work, yet every other light and gauge does I have 1 wire coming from the back of the rev counter (its a yellow wire with a violet stripe) its ...
Moving to a location with access to leaded fuel and diesel only. Will Honda VT125 Shadow run okay on leaded fuel? Yes, it will run good on leaded fuel. As a matter of fact, you will probably notice ...
...plug is to big or maby faulty try new one or your old one is it possible something coul be stopping fuel and 2stroke oil mixing and causing my honda lead 125 to not start turns over but wont ...
suzuki intruder 125 2004 no spark check ht lead is pressing against the spark plugs check the spark plug gap and replace ht leads and plugs if need be cheers
Question about Vespa Scooter
125 px I can't get leaded petrol what can I use ? All Vespa's old or new run without need of lead as your engine internals are lubricated by either the gear oil or 2 stroke oil. The old PX
no spark on my yz 125 2006 model check change spark plug. check ht lead and cap. check earth to engine from battery
...plug on an Aprilia Atlantic 125 FOLLOW THE SPARK PLUG LEAD DOWN TO THE ENGINE, GENTLY REMOVE THE CAP, THE PLUG IS THERE, POSSIBLY AN 18MM DEEP SOCKET TO REMOVE, CHECK IN THE TOOL KIT IF YOU HAVE
Question about 2003 Atlantic 125
...it it ?? Derbi Mulhacen cafe 125 4t E3 2007-2014 i have the 2009 model disconnect the positive lead at the battery, leave off for 5 minutes, reconnect and see if that doesn't reset the service
...125 Follow the live lead from the battery it will go to the starter solenoid,disconnect it from the solenoid by undoing the bolt that holds it on then undo the other fat lead that goes to the starter ...
Question about 2000 VL 125 Intruder LC
tried to jump start my brothers yamaha 125 xmax 2013 the jump leads was put on the wrong way round blew a 30amp fuse tryed to jump start my brothers yamaha xmax 125 2013 and jump leads was put on the ...
Usually answered in minutes!
Step 2: Please assign your manual to a product: