...125 weak spark won't start Not much info Smitty but if that weak spark is constant (ie:pulsing ) i would guess that the trigger coil is ok.I'd make a check on your ignition coil earths then do a ...
...125 i have fire from the scatter plate to the cdi box i also have fire from cdi box what i need to know is how to hook it up to the kill switch and the coil you run the positive lead from the cdi to ...
Sparks from wire leading to ignition coil. Hi, i have a Yamaha XV Virago 125 1998. Having replaced two ignition coils, replaced all the female connectors going to the coils, i am still having sparks ...
...125 It is normal for the powervalves to leak, but it does depend on where it is leaking from. The hose on the left side is the power valve chamber vent - it is normal for it to leak thick black oil ...
After changing the battery on my yamaha xmax 250, the bike will not start even when using jump leads, could I have blowna fuse ? where are the fuses located ? fuse should be next to the battery. ...
yamaha dt50r 2004 which order does the wires go on the coil king lead upwards. on most coils terminals are + and _.12v goes on + and _goes to points
...125 03 model and its splutters after 7 grand in every gear it must be fuel/power valve problem Firstly, when riding this bike do not ride past the splutter, this could be for. Number of reasons, ...
...compression remove the spark plug and install a screw in type compression tester ,isolate the HT lead , turn on the ignition and turn engine over 30-60 seconds. Take reading and compare to ...
no spark on my yz 125 2006 model check change spark plug. check ht lead and cap. check earth to engine from battery
Question about 2006 yZ 125
tried to jump start my brothers yamaha 125 xmax 2013 the jump leads was put on the wrong way round blew a 30amp fuse tryed to jump start my brothers yamaha xmax 125 2013 and jump leads was put on the ...
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions