open the door using the emergency unlock knob. I have replaced the door interlock and the problem still exists. Any suggestions welcome. Thanks, David It seems that your problem is with the lid switch
...the plug was pulled) however, I have removed the lid and there is power to the machine, any suggestions possible interlock, the switch that stops it from working when the door / lid is open start ...
Question about Lavamat 72640 Front Load Washer
open a AEG Lavamat 805 front load washer Something (probably a plastic obeject,comb, ...) has left the drum and found its way into the interior part of the machine. Now giving all types of sounds when
AEL Lavamat 509N hi there. purchased secondhand machine as moving in with some mates. the machine doesn't want to relinquish washing when finished...door stays locked. need urgent assistance. thank ...
...this sounds like the fill vavle is fauty you can check this if you have a muiltmeter. remove lid and unplug the green soliaod and check to see if open circuit. if so replace and should be ok. ...
Question about Lavamat 16810 Front Load Washer/Dryer
...top and out the bottom. Then yank it to the left to open the lock. It will take a few tries but you get the hang of it! We got sick of this so ordered a new lock off the net. I basically had to break ...
...Open the sieve lid, (lower right of machine) and clean. Drain tube bent or blocked. Check for bends and straighten the tube, open hose band clips and check inside for objects or dirt. Some small ...
...stay wet Hi, if it doesn't spin, check to see if the motor is running, then proceed as follows: If the motor is running, your washer probably has a frozen pump pulley or a broken pump belt. To ...
Question about Lavamat 74640 Front Load Washer
...open the lid- grab the inner basket with maybe 30% to 40% of your hand strength with your left hand - turn on the machine and bypass the lid switch by depressing the lid switch with a key until the ...
Question about Lavamat 74640 Front Load Washer
...Open the machine up on the top lid. 2 screws at the back of the machine at the top. Slide the lid back and remove it. The drawer can now be accessed. There should be a bunch of clips holding the lid ...
Usually answered in minutes!
181 Questions
148 Questions
95 Questions
55 Questions
58 Questions