lid switch. This is a tell tale symptom of a lid switch gone bad. The washer fills, agitates, but will not spin or drain. The lid switch is located along the right hand side of the lid opening on most
lid switch is located left rear corner just behind lid hinge if switch is on right side close lid slowly and listen for click if none heard try pressing down on lid at switch location if washer starts
Question about Ultimate Care II LSQ9549L Top Load Washer
lid switch. If the washer fills and doesn't do anything, or stops right after the wash cycle and then does not advance to the rinse cycle and drain, this is commonly caused by a lid switch malfunction
lid switch. To test for this, lift the washer cover and look for a small hole in the washer top where the cover was. Push a toothpick gently into the hole and press the piece of plastic you see in the
Question about Ultimate Care II LSQ9549L Top Load Washer
...lid switch. If the washer fills and agitates, but stops at the rinse cycle, this is a common symptom of a lid switch malfunction. The following link explains how to access and/or replace one: ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...lid switch. If the washer fills and agitates, but stops at the rinse cycle, this is a common symptom of a lid switch malfunction. The following link explains how to access and/or replace one: ...
Question about Ultimate Care II LSQ9549L Top Load Washer
lid switch The most common cause of the symptoms you describe is a lid switch malfunction. The lid switch is usually mounted under the washer top casing, on the right hand side on most top load models
...lid switch is not functioning properly. Raise the top part of the washer to gain access to the lid switch. Disconnect the machine from the power source. Gently pry the emblem from the front of the ...
...lid lock switch and won't work Thought it was the lid lock switch and it fills up but won't wash so we changed the lid lock switch Is the plunger attached to the lid? It is the little prong that goes ...
...lid switch. The lid switch on a top-load washer is a safety switch that detects whether the top-load washer lid is closed. The lid must be closed when the basket spins; some top-load models require ...
Usually answered in minutes!
9,125 Questions
2,624 Questions
2,038 Questions
1,413 Questions
1,373 Questions