...Install sensor shield. Install the sensor mounting stud and tighten to 24 N·m (18 ft. lbs.). Install the brake line on the sensor stud and install the nut. Lower vehicle. ,I hope this helps
...sensor line and the wires -- if all is clear and looks good,, I would say that it is the sensor itself. by removing the back panel of the machine - you should have full access to the sensor,wires and ...
...sensor, or a leaking vacuum line somewhere. The bad readings from the MAP sensor will cause the trouble code with the oxygen sensor (and the reason why you failed the test,) but this is not to say ...
line from the pressure sensor and blow through it - it may be blocked by lint and soap from several washing cycles. There may be a filter in this line to help prevent this blockage. But the filter may
...line pressure sensor (Fig. 83).2. Remove the bolt holding the line pressure sensor to the transmission case.3. Remove the line pressure sensor from the transmission case.INSTALLATION1. Install the ...
...sensor. I tested each line and I got .3 ohms when doing each line. I crossed lines and came up with nothing which i believe that to mean the lines arnt touching anywhere. When i cross the ground with ...
...line sensor removal I am trying to replace a line sensor on an HP DesignJet 6100. The new unit includes a ribbon cable the feeds under a plate on the print head assembly. I can't see a way to remove ...
...Remove the oil filter and capture any lost engine oil in a container. Loosen the oil cooler lines at the engine block. Back out the fittings far enough in order to gain sufficient clearance ...
line from the pressure sensor and blow through it - it may be blocked by lint and soap from several washing cycles. There may be a filter in this line to help prevent this blockage. But the filter may
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
