Questions & Answers for: loose rotor

Question about 2005 VUE

3 Answers

...loose then u can get to the nut to remove the rotors danger do not remove big nut in middle that is axle shaft nut. To remove rotor you need to bang on surface of rotor between lugnut studs and on ...

Ad

...loose. if you plan on reusing the rotor spay it with some penetrating oil then lightly tap on the hub to break it loose. good luck There are locks on the Charger.Go to AutoZone they will give you a ...

Ad

...rotor in distributor ever 1000 miles 1) Loose bearing/bushing in distributor body. (The shaft that the rotor screws down to, goes through a bearing, or bushing, in the distributor casting) See if you ...

...off rust or put any lube on the hub or rotor, at least once a year,and now the rotor is rusted on. Put a penetrating lube on center of hub/rotor and use a block of wood to tap and vibrate it

Question about 2004 X-Type

1 Answer

loose) and hit the center portion of the rotor (part that the studs go through) with a hammer. Do not hit the part that contacts the brake pad. You might have to hit it hard so use a 2-3 lb hammer and

...rotor. (most replacement rotors omit the screw holes). Rotor will then pull off. If it is frozen in place, a couple of strikes to the rotor edges with a RUBBER mallett will usually break it

rotor for brakes is very loose. Looks like rivits are expanded Hello, The rotor on your motorcycle is a full floating rotor and the outer portion is supposed to " float ". It normally has side to side

...loose, adjust if possible, otherwise replace the bearing. Before Removing the Brake Rotor from the vehicle it should be tested for warpage. Use a Dial Indicator for checking to see if the rotor is ...

Question about 1996 Discovery

1 Answer

...rotor near the hub to pop it loose.you may have to heat up the rotor with a torch and hit it again to get it loose.if it uses an e-brakes system inside the rotor(the part that looks like a drum) then ...

Question about WM2455 Front Load Washer

1 Answer

...rotor bolt was loose, probably from the factory as the unit has been used less than two years. When I inspected the rotor, the plastic insert that is screwed into the rotor housing and provides the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...