...loud grinding noise when the clutch is pushed in. Sounds like a clutch release bearing locked up, or pressure plate damage. In any case its obvious that the prinny has to come out and look inside to ...
...loud grinding noise and feeling in the pedel. Is the shaft on the slave cylinder in incorrectly? if so, how the HE@! do I make sure it's in properly? the forck for the throwout bearing has fell off ...
...grinding sound before the starter went out?? or even a loud sound when it would turn over would indicated a bad flywheel. meaning the teeth on the flywheel has been chewed off. pull the starter off ...
...loud thuds and grinding in a very bad way. The only time it did not occur was when i was eccelerating. When I got home, I noticed there was tranny fluid all over the rear end but couldnt see any ...
Question about 2006 Wrangler
...loud clincking or grinding when turning I have a 2006 Jeep Wrangler when I am at a stop light and I accelerate on a right or left hand turn its makes a loud clicking from the under the jeep. The Jeep ...
Question about 1997 Wrangler
...loud grinding noise but will drive in reverse Was just driving down the road and Jeep started to squeal really loud then started making a loud grinding sound. Pulled over and when I tried to take off ...
When u shift into fifth gear makes loud vibration and grinding noise all other gears are normal sounds like a bad bearing in trans
...loud metalic pop. i then noticed that my 2 high was completely disengaged even though transfer case shifter had not moved. after comming to a stop and playing with it a bit i noticed that my 4x4 is ...
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions