...idle adjustment hi & low r mixture settings if your not sure don't play with hi or low settings hope this helps Hi High speed H=3/4 turn Low speed L=1 1/4 turns Adjust T accordingly cheers ...
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...low. Your high adjustment idle screw needs to be adjusted. Firefishin is right I have a Stihl 028 Woodboss chain saw and of had the same problem until i touch the low idle screw it sloved my
idle. H is high; L is low; T is throttle, throttle is your rpms. On the 'T' turn it clockwise until the chain starts moving. Then turn it counter-clockwise until it stops the chain from rotating. This
Question about "Chain Saw - 16" Bar, 3 Hp
19.5 hp rough idle. Galloping idle and at low rpm 19.5 hp Briggs and Straton has rough idle. Galloping idle and at low rpm Definately a Hard-D problem; replace it.
the idle on the 353 saw. it will start and run but wont idle, then it shuts off. fire it back up and same happens There should be a idle screw adjustment on carb.if not try adjusting the low speed jet
idle required. With all the modernization happening, there might not be a high or low adjust as they are ported inside the carb. You might get just the high or just the low adjust needles. I hope this
idle's low when i drop the deck my engine idles low when I engage the blade and when the deck is lower. Used to get a lot more horse power to but seems to be getting less. if you want help then ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...idle adjust) so it doesn't stall, adjust low-end screw so that engine doesn't hesitate or sputter when accelerated. Adjust high-end screw to run fast and smooth on full throtle. Readjust idle to ...
I have a yth2148 Husqvarna that idles high and low. I've changed the spark plugs gas filter oil filter fresh oil and lawnmower still idles high and low with blades Not engaged. I also used carborater ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...low speed, increase the idle speed. If you can't get idle adjusted without it dying, then likely you have other issues with the carburetor, spark, compression (crankcase seal) or even blocked spark ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions