Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...low idle needs to be adjusted this is fairly common among the Poulan chain saws. Once you adjust the low idle from factory setting it will work Also, increase the amout of oil you're putting in your ...
...low idle. It has the big back wheels. It also says mulcher on it. It is not gummed up with grass. The throttle sticks so I just put WD 40 on it. Like I said it is running at a very low idle and using ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
what is the proper setting for the hi low idle screw for a poulan 2000? the setting is aprox 1 1/2 turns on low idle and aprox 1 1/2 to 2 turns on high
...low speed idle won't adjust to make it keep running. The theory is much the same on all chainsaw carbs, start and warm the machine up, increase the idle speed with the idle screw if it will not tick ...
...idle, high, and low.. if you look air filter cover you will usually see three holes and the high and low will usually have plastic covers on it.. adjust the low 1/4 of a turn and the idle screw in ...
...low idle will not rn under low idle or when loaded. Fresh gas.new fuel filter and fuel lines and clean carb and screen and make sure your diaphrams are good, preset your jets 1-1/2 and run and fine ...
to adjust idle on my chain saw. It will not idle and needs to be adjusted up. Won't idle when you are not cutting. Adjust the low side out another quarter turn first before messing with the idle screw
...idle. I am not sure how to do this. First start with the initial settings on both low and high side. They need to be 1 full turn out and the idle is set so that the throttle plate just starts to
Question about Pro 42CC 2 Cycle Chainsaw, 18"
on poulan pro 50 cc won't idle. Idle screw doesn't affect the speed do I need to increase or decrease low screw it runs good at high rpms adjust both till it runs perfect or set the idle screw up some
Question about Pro 14" Gas Chainsaw 33CC P3314
low speed and lower idle rpms by turning out idle throttle speed screw. Then with throttle wide open adjust high speed mix. If saw hesitates from idle to full throttle, open low speed mix 1/8 turn and
Usually answered in minutes!
583 Questions
457 Questions
255 Questions