Questions & Answers for: lug bolt

Replacment of wheel lug bolts on rear wheels Can the lug bolts be replaced without pulling the axle and what is the easiest way to do the job. Have ample tools but limited knowledge of car, belongs to

...lug bolt tire broke off. i bought the new lug bolts, put them on, and now my tire is wobbly and sounds weird. sos assuming the bolts that broke, broke while the vehicle was in motion, the wheel is ...

...tighten the lug bolts. With the wheels installed and the vehicle on the ground, tighten the lug bolts in a crisscross pattern and then the axle bolt as follows: Wheel lug bolts: 89 ft. lbs. (120

...bolt with the lug nut. I put the nuts on upside down and used a 7/8" wrench and mallet to tap on the wrench to get these as tight as possible. You also have to tap on the head of the bolt and repeat ...

lug bolt is installed, and tightened on the lug bolt, the bolt stretches. Eventually the bolt will weaken. If the lug bolts have been put on by an impact wrench, this could turn out to be a real issue

...lug bolt style, etc. All this is essential to know before giving exact answer. But general advice is that if it was a bolt that broke that had been pressed in, you can usually knock it out with a ...

how to change front brake pads on 2006 town and country Loosen tire lug nuts. Jack up the car and remove lug nuts and tire. Remove two bolts holding the caliper in place. Remove the the two bolts ...

...lug nuts snapped bolt off. How do I change lug bolts out to new one. Plan to change all for bolts and lug nuts for this tire. take tire off, take brake caliper off, remove rotor, take nut and bearing ...

...lug bolt broke when i removed the nut. to fix the brakes. how do i get the lug bolt out? jUST TAKE ALL THE LUGS NUTS OFF & REMOVE ROTOR WITH A 5 LLB SLEDGE HAMMER KNO0CK BROKEN BOLT & REPLACE ...

...converter attaching bolts. Tighten bolts to following torque: 40 ft. lbs. (54 Nm) with 9.5 in. 3-lug converter 55 ft. lbs. (74 Nm) with 9.5 in. 4-lug converter 55 ft. lbs. (74 Nm) with 10.0 in. ...