...went out last night and now my hotpoint sy36k oven wont heat up. i dont know if the oven caused the mains to go out or not. all the lights,fans and controls work but the oven wont get to temperature, ...
Question about Ultima WD72 Front Load Washer/Dryer
Need to find the filter as drum not spinning and water leaking I have water leaking from the front bottom of my waher dryer and the drum will not spin. Have been told to clean the filter and hose, but
Question about Ultima WF860 Front Load Washer
...changed the fuze in the plug but to no avail, please help . possibly mains lead you need to check there power coming out from mains filter the other end of lead-if not you can purchase a lead ...
what does F-11 mean on a hotpoint CTD 80 It means that the pump is disconnected. You need to check the pump to see if that operated or with the aide of a multimeter, see if it has an open circuit - no
...fuse checked plug socket emptied water tank cleaned both filters power comes in at mains lead goes to the choke /filter from here onto the door interlock switch then onto timer ......hope this ...
...mains lead goes in to the appliance and follow the cable until you find the main fuse. ONLY USE THE SAME TYPE AND RATING OF FUSE TO REPLACE IT. The usual cause of this fuse failure is the door ...
...mains lead goes in to the appliance and follow the cable until you find the main fuse. ONLY USE THE SAME TYPE AND RATING OF FUSE TO REPLACE IT. The usual cause of this fuse failure is the door ...
Question about Ariston AW125 Front Load Washer
hotpoint aqualtis aqgd169s no power wont turn on not even had an error code come up Wont work at all no power no error code If the machine is dead, I would check the cable from the main boad leading ...
Question about Ariston AW125 Front Load Washer
...mains lead normally goes to a connector block at the top of the machine then onto a mains filter both of these can fail ie burnt out connections ect check these out first remember to un-plug machine ...
Question about Ariston AW125 Front Load Washer
...mains lead for continuity! Thats making sure the lead to the dryer is not broke anywhere internally. It may mean removing panel to get access to where the mains lead goes into the dryer, You can do ...
Usually answered in minutes!
69 Questions
52 Questions
44 Questions
18 Questions