...maytag legacy series top loader. I have a presumed main bearing seal leak. However, I can't seem to figure out how to remove the round "disk" above the seal. (the one with the shaft going through it) ...
...Legacy leaked on floor and subsequently ruined gararge ceiling. I put a wash in yesterday, filled it shut it off and left it soaking. I returned home from my errands three hours later to an 3/4 empty ...
Question about Legacy Series Top Load Washer
...Maytag ! Any information or suggestions would be deeply appreciated. Both the washer and dryer ar no more than 3 1/2 yeras old, I thought a "LEGACY" lasted forever ?!?!?!? S/N134694ER, MOD SAV405DEWW ...
water vavle. You can go on line and order parts from almost any source. I like repairclinic and partselect go to Google and google your Manufactures name and parts, ex Maytag parts. You will need your
Question about Legacy Series Top Load Washer
Maytag sav515daww washer leaks while filling water. I opened the washer and found a hole in the drain hose and the water is leaking through it. Since water is leaking while filling, could this be a ...
Leaking water from underneath somewhere. How do I get it apart to find the leak? best way is to tilt it a bit (with 2x4 or something) when it starts leaking, find out whats leaking with a mirror and ...
Question about Legacy Series Top Load Washer
water is leaking from washer when the process of washing is in action. Checked the hoses not leaking from them most likely the pump seal is worn
...Maytag mav208daww won't hold water. When I start the washer the water does not stay in the tub, it immediately goes out. It doesn't fill at all. The water leaked out of the bottom of the washer the ...
Question about Legacy Series Top Load Washer
water leaking underneath. the back of the washer and all the hoses are dry Check behind , nothing like looking at the fault than to speculate. Can be due tto many reasons but unless the source of leak
Question about Legacy Top Load Washer
...maytag legacy. 9 years old. getting worse over 3 months. removed front and rear panels, dried out and looked for leaks. only water was on agitator base. im thinking tub bearings and seal. any other ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions