...by closing it several times till it catches but if it completely shot then that wont work you could pull the plug jump the switch and clost the door and plug it back in the pause llight should go ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
maytag neptune front load washer wont start when button pressed plugged in, door closed, detergent added and detergent door closed, dial moved to correct setting and other button selections pressed ...
Question about Neptune MAH5500B Front Load Washer
MAYTAG NEPTUNE DOOR LOCKED WILL NOT OPEN! will not complete wash or any other cycle displaying "d o" assuming "door open" then "FL"???so wont operate... yet has been locked with wet load for two days ...
Question about Neptune MAH5500B Front Load Washer
Maytag Neptune wont operate displaying "d o" but is locked was locked earlier but found cord to unlock now still wont operate displaying "door open (d o)" is closed tightly ??? Replace the wax motor ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...watch what happens when u turn it on i believe you make have a loose drain connection i have a maytag neptune washer model # mah6500aww an it is field with water that wont drain out what should i ...
wont close all the way. Do I replace the replace the lock mechanism module? If the interlock isn't working it may not allow the machine to start. If you can open the door when it should be locked it's
...Maytag Neptune. If its lock problem then how do I get at it to replace it? Cut and paste this factory service manual. It will show how to access,test and replace all components. ...
Maytag Neptune MDE6800AYW shows error DO (Door Open?) bu the door is closed and the machine would not turn on door switch, it is located inside the dryers front panel, there are a total of eight ...
Question about Neptune MDE5500AY Electric Dryer
dryer wont heat and wont shut off unless door is open The relay for the motor is stuck closed on the control card. Get a new board from local supplier.
Question about Neptune MAH9700 Front Load Washer
...Maytag front load washer , powers up and lets me change the settings, but when I press the start button , it beeps and displays d5 and wont start?? this fault code ind a door lock problem ,hence this ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions