...Maytag washer, MAV6200AWW, on more than one occasion it has not completed a cycle. It was do to imbalance. Is it the timer? When would the washer stop? Is there water in the washer when it stops? my ...
Maytag washer about 20 years old. Fills OK with water but will not agitate. Cannot hear timer ticking at any time. Thanks. You might have a sensor problem that prevents the cycle from proceeding. Most
Maytag frontload washing machine. I have unplugged it...to reset and sometimes it works. Other times it doesn't. How can I fix it? The F35 error code indicates an analog pressure sensor error. The
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
...Maytag washer had this same problem After about two years it suddenly started agitating as soon as water began to run into the tub. I changed out a few parts without success. Then I noticed a clear ...
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
Maytag Washer won't agitate after filling My washer has an auto water level sensor. When I load it and turn it on, it fills with water, but it will not agitate nor advance through to the rinse and
Question about Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer
...maytag front load washer I would like to fix this myself "F24" is an indication of a water temperature sensor (NTC) error, or Heating Circuit failure. Check the Water Temperature Sensor and check ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...MayTag washing machine - F3 & E2 error codes. I cleaned out the drain trap then proceeded to remove the top and rear panels to check the Temperature Sensor. The sensor was tested with an Ohms ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...maytag washer was the lid switch and i fixed it, it was bent and I straightened it out and works fine recently i had some old sheets in a shed -sheete were covered with dirt and leaves and dusted off ...
Question about MHW6000XG Maxima High-Efficiency Front Load Washer
maytag maxima front load washer will not fill with water when started and is not giving any error code what would cause the washer to not fill with water when started and not give any error code water
Question about Bravos MTW6600T Top Load Washer
Maytag Bravos washer. It powers on and sending light comes on for a few seconds and it powers off? It is likely to be a failed control board. They are expensive so call for service. Then you get the ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions