what are the head torque settings for a 4cyl 95 camry? FIRST STAGE 25 NM stage 2 49 nm stage 3 90 degres
i am asking for torque specification of toyota tazz for cylinder head head bolts are usually torqued in three stages. i believe the settings for yours are three stages of 25ftlbs. this means the first
what is the torque setting of mains, bigends and cylinder head of 1zz Toyota corolla 140i Torque: - Connecting rod (big ends). Tighten bolts in several steps. 1st stage 29 NM, 2nd stage, rotate ...
Question about 1990 Corolla
i need the torque setting for head cylinder on 1994 toyota camry 220se Torque the cylinder head bolts in three stages as described below: 1st stage = 25 NM. 2nd stage = 49 NM. 3rd stage = Rotate each ...
Question about 1990 Corolla
Hi I need the torque settings for both the cylinder head and the bottom end bearings for a 1997 Toyota Prado (3.4litre petrol). Thanks 1997 Toyota Prado 5VZ-FE Cylinder head bolts: Tighten the ...
Question about 1996 Land Cruiser
toyota 80 series GLX auto landcruiser 1996 need head bolt torque a nd cam shaft torque settings need head bolt torque and cam shaft torque settings Torque setting Toyota Land-cruiser 80 Series 4.5 ...
Is the fuel pump for this truck a two stage pump? do not think so but call a local dealer/service and ask them Depends on the year and make of the car. Some are 2 stage some are single stage. Toyotas ...
Question about 2006 Corolla
microscope is invaluable), can provide useful indications of what further action to take; clean and flush the tank, replace some or all of the pipework, change the fuel filling stations you use and so
Question about 2006 Corolla
Toyota corolla cylinder head torque specification 1.6i 3zz engine Cylinder head bolts are tightened in three stages: Stage 1. 25 Nm. Stage 2. 49 Nm Stage 3. Rotate each bolt 90 degrees in a sequence.
Question about 2006 Corolla
Hi! I need torque values for cylinder head bolts. Toyota fortuner 3.0 D4D the info that i have is to check bolts are ok and threads are not stretched minimum width @narrow part 11.6 mm but i would ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,231 Questions