Questions & Answers for: mini split condensation problems

mini-split unit is quiet and blows super cool air, but I find a small drop of yellowish oil on the lower left side every morning. Is that compressor oil? How is it getting into condenser unit? Is it a

Mini-Split Not Cooling? : ( Hi, My York 12000 BTU mini-split is not cooling and don't know why... The indoor wall unit works fine. The fan is rolling. We can feel the air is moving in normal condition

Mini split. Starting up A/C for the first time this season. Condensate dripping from the front of one of the inside units. some water running out Condensate line. It does not appear kinked. System was

...mini split heat pump occasionally shuts down in cooling mode while displaying the code CA. The LG tech tells me there is no such code. When this happens, I have to cycle power off and back on to the ...

Mini Split Condensation Problems! We have a ProTech - Rheem mini split in our new house. Both bedroom and living room units were mounted on interior walls. The installers said that was fine. ...

...Mini Split when the thermostat cycles it trips the circuit that controls the unit what could be the problem? WHATS YOUR QUESTION? condenser unit cuts out less than 5 minutes,inside unit is still ...

leaks water into the house from the inside unit serial no: 106KA02427 condensation problem may have t-stat set to low do not set unit more then 20 degrees lower then the outside air temp may also need

mini-split Hello We just installed a Sanyo KHS1271 mini-split system in a new addition. The unit works great for heating and cooling the space. We shut the unit off at night and the next morning there

the unit is leaking Sounds like your main condensate drain line has clogged and either there was not an auxilary drain line installed and it is leaking out of the pan OR the float switch has gone bad ...

...mini split is blowing 80 degree air. The other head is functioning properly. There is only one condenser for both units. any ideas? Possible, Refrigerant not flowing due to shut valves or solenoid ...