...Dough Hook on A200. I bought an old Hobart commercial mixer. Its in great condition. The only problem is there was no instruction book nor parts book with it. The p roblem is the dough hook Is in the ...
mixer. I was making bread when the machine started to make a strange noise. The dough hook still spins, so it cant be the motor. The other problem I have is that the dough hook is stuck on the machine
...mixer from the shaft it was not taken off after the last time it was used and now is stuck on any ideas Renato20,Either the hook is worn or the beater shaft pin is worn or dough has built up around ...
Dough hook stuck in machine I have a Kenwood mixer KMC510 and am now on my 2nd machine because the dough hook became stuck in the first one and the unit was replaced. Now after only a few uses the ...
Question about KSM50PR Professional Series Stand Mixer
...mixer The dough hook is stuck in the beater shaft of my kitchenaid mixer. I can't get it out. It sounds like it got overloaded when you last mixed dough. It will only come off the way it went on. If ...
...mixer so when I tried to release the dough hook by lifting and turning, it wouldn't lift. The bolt was in the way! The solution is to loosen this bolt. You'll need a thin wrench that's about 15 mm. ...
Question about KSM90 Ultra Power Series Stand Mixer
cannot get dough hook out of slot pin seems stuck run under hot water over where the dough hook attatches to shaft. this should free it.
...Dough Hook 1. Turn speed control to OFF. 2. Unplug stand mixer or disconnect power. 3. Tilt motor head back. 4. Slip beater onto beater shaft and press upward as far as possible. 5. Turn beater to ...
Question about KSM150PS Artisan Series Stand Mixer
...mixer has a scream when using dough hook. I was making bread. I have made this recipe many times. I had 6 cups of flour in my mixer and was letting it knead. Suddenly the hook stopped like it was ...
...dough hook is stuck in my K mix kmx50. Please note, this is not the 'normal' problem with the tool becoming jammed because there is not enough clearance to push upwards (I've done that before and I ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions