door unlocking. Mode 2: No automatic door locking or unlocking. Mode 3: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed
...mode, the integration relay automatically performs the power door LOCK to UNLOCK operation within 3 seconds to inform the selected mode. ? In the confirmation mode, when the operation is performed ...
...mode was selected, door locks will cycle 0-4 times depending on how many transmitter codes are stored in ECU. Example: two stored codes equals 2 door lock/unlock cycles. 5) Complete the following in ...
mode door operation DESCRIPTION The mode door actuators are reversible, 12-volt direct current (DC) servo motors. The heating-A/C systems on this vehicle use two mode door actuators. One for the panel
Question about 2011 Liberty
...mode door actuators (1) to control the movement of the mode-air doors within the HVAC housing. When vacuum is supplied by the A/C-heater control to the vacuum connector (3) on one side of the ...
Question about 2011 Liberty
...door lock switch. Mode 2: The system arms when you lock the doors with the keyless entry transmitter. The system disarms when you unlock the doors with the keyless entry transmitter. The system does ...
...mode door ? Temperature Blend Door Actuator - LH Removal and Installation NOTE: It is not required to install the new LH temperature blend door linkage parts included in the LH temperature blend door ...
Question about 2009 MKS
...mode door actuator through the mode door control circuit. Zero volts drives the actuator in one direction while 5-volts moves the actuator in the opposite direction. When the actuator receives 2.5 ...
...Mode" door actuator or a stuck mode door. That door is responsible for directing where the air comes out. Locate the mode door and disconnect the actuator. Move the door by hand. If it moves freely, ...
Question about 2009 MKS
,it's a mode door ,an it's not a fuse . You need a need mode door actuator . The heating / A/C control panel controls the position of the mode door . Your best bet , take it to a qualified repair shop
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
