Routing vlans on 3com switch 4500 Hi, I have not been able to find the command to routing two vlan on a 4500 switch. I thought it was like on cisco switchs "ip routing", but in 3com does not exist ...
how can i access it using telnet? if it allows telnet sessions, you would go to a command prompt and type: telnet 192.168.1.2 (or whatever the IP address of the switch is.)
Question about 2250 Plus (3C16476CS) 48-Port Ethernet Switch
need to know how to log into a 3c0m 4500 switch tand the commands to set it up This site should have everything you need. 3Com PDF's for the 4500 switch
how can configure trunk how can i configure trunk in 3com 4500 with cisco not sure about the 3COM side, but on the Cisco side... go to the configure prompt, then the port that you need to trunk (int ...
I have a 3com 4500 connected to 2 5500s (A & B), which are the the GWs for the 4500. I issued on the 4500: ip route-static 0.0.0.0 0 192.168.0.254 preference 60 (5500 A) ip route-static 0.0.0.0 0 ...
Question about 4500G 24-Port Gigabit Ethernet Switch (3CR17761-91-US)
3Com 4500 Gigabit ethernet switch hangs after 3 minutes. Has to be rebooted. yes reboot and than it will run properly may be some load issue on your switch
...4500 26-ports. I am currently using computer Laptop model Acer Spire 4935, and my computer has no serial port. So, please you advice me how can i deal with this problem. Best regard! YANN SOPHEAK ...
I have forgot my admin password in 3com switch 4500 could you please help me Search the following documents for 'Password Recovery': ...
I have 3com 4500 switch , I have created 4 vlans , Vlan 1, Vlan2, Vlan 3, Vlan4 Vlan3 range should be from 10.88.120.0 to 10.88.120.127 subnet : 255.255.255.128 I created Vlan3 Interface as ...
4500 model and the default username and password of the device Username:monitor Password: monitor---monitor mode, view only manager manager--can change all except security features admin (no password)
Usually answered in minutes!
104 Questions
51 Questions
49 Questions
40 Questions
42 Questions