Question about Champion 10,000 All-in-One 10,000-Watt AC Generator and DC Welder with Robin Engine #500433
...power to run anything. measure ouput on ALL available sockets - anything? Take cover off electric motor-generator, visually inspect windings. Measure continuity of all stator windings (2 or 3
...motor start winding, the start capacitor and the start switch (probably electronic in your case which is a small silver box with four wire terminals on it). The capacitor should be tested with a ...
...Motor start winding The start capacitor is located at the rear of the mixer. Remove the rear cover (4 screws) and pull the cover towards you. Disconnect one wire from the capacitor and test with any ...
...winding, there should be less than 5000 ohms. If no continuity replace motor. If continuity- oil the shaft with light motor oil and see if it releases.If no voltage is measured at motor ...
Question about M-802 80qt Dough Bread Bakery Mixer 80quart
...from overheating. There may be a thermal cutout on the start winding that may need to be replaced if it did overheat. If the start winding burned then the motor would require rewinding or
...starts if it does it go in the reverse direction How old is the mixer? Could it have a brush style motor? Easy to tell. It will have a couple of removable panels on the motor rear cover. The brush ...
why is my hobart mixer smoking? The windings inside the motor are heating up from either a prolonged over load from too much or too thick ingredients in the bowl or there is a short in the motor. ...
...capacitor(s). - is unit three phase? Check for missing leg(s) or bad wiring conections. Next check motor windings and for shorts also if it is mechinal binding up. If motor is good , check for ...
Question about A200 Stand Mixer
motor and it Generates. The Phases refer to the THREE Windings in the supplying generator in your suburb. A Large Magnet passes each winding in sequence giving you the three ripples in the supply. Our
Question about A200 Stand Mixer
...winding" on the stator? think a mixer is going to have a motor with higher starting torque. Are there brushes in the motor cause those look like part of a brush lifting mechanism on a repulsion start ...
Usually answered in minutes!
111 Questions
26 Questions
20 Questions
13 Questions