Question about HYG2460AWW Gas Dryer
...motor's start winding is open (broken). It doesn't looked like a switch problem. My suggestion : - open the drayer and see if the belt wrapped properly arround motor's pulley and drum and not torn. - ...
...disconnects the start winding and the motor continues on the run winding. possibly either the capacitor or motor winding is defective. Let me have the machine details may have a good motor UK
...open if motor winding check at pin 1 to2 1to 3 2 to 3 each should read at about 3 ohms if mtr checks good you'll need control board pn 34001497 or 3400469 depending on series $220 mtr pn 34001269 ...
...When you push the button to turn it on it will hmmm but will not spin. Ok, this is electrical motor failure. you will need to replace the motor in this case. the hum is a sign of electrical ...
...motor is defective. It has two sets of windings, a start winding and a main winding. The start windings are to get it moving so that the main windings aren't stressed when power is applied, and there ...
motor winding has short circuits. Remove the rear panel to access then pull the drive belt while turning the drive pulley to remove it. Once the belt is off, turn the drive pulley and the motor pulley
... If this doesn't clear up the problem, the motor winding could be shorted already or the centrifugal start switch could be damaged beyond help by cleaning / lubricating. More info, let me know. ...
Question about MBB1954G Bottom Freezer Refrigerator
slides on the compressor pins. What it does is allow all the copper windings inside to power up the motor. When the motor gets going it also drops out half the windings in the motor. Gives the motor a
...winding on the motor is bad, all dryer motors have a run&start winding on the motor, the start winding comes on at the beginning to give teh motor a extra little ummph to start the motor then the ...
Question about MBB1954G Bottom Freezer Refrigerator
...motor. Another possibility is the start winding (button controlled) is not disengaging. This could be as simple as the push button to start the motor is cloed all the time or does not become ...
Usually answered in minutes!
1,743 Questions
867 Questions
815 Questions
489 Questions
196 Questions