Questions & Answers for: Yamaha XVS 1100 Dragstar motorcycle kick starter problems

have problems starting yamaha xvs 1100 dragstar slugish on acceleration until warmed up 10 min + backfires on deceleration and when letting off gas Hi there fellow XVS dragstar owner! I had the same ...

...starter but got her goin by push start, has my battery had it or???? help!!! With your engine off, measure the battery's poles with a voltmeter and you should not see less than 12,5 V.If you do, your ...

...starter was broke, so I need to replace it. I'm looking for a quotation. When can I buy new original pieces? These parts are fairly reliable. Rather than buying new, you should be able to pick one up ...

Starter Relay kick in. I tested it manual though and it is OK. Since teh lights DIM when I press the start button, I know that button works. So whats left? The solenoid? chec fuses-bad ones can appear

my 1100 just spins wont turn motor over Hi, It sounds like the starter is not engaging to the engine. Pull the starter and have it checked. Disconnect battery first. :o) Good luck! Hellow.Look here. ...

...starter I changed it but it still won't start Hi, Latwell_lady and the usual suspects are: 1. Fuel tank empty. 2. The fuel tank has old dead gas. 3. Fuel tank bottom contaminated with ethanol sludge, ...

...kick over seems like a relay or switch cause it wont even click Do any lights come on when the key is turned? Are you you sure there is power from the battery? If yes then what happens when the start ...

starter switch when push the button nothing happens Hi, Anonymous and the usual suspects are: 1. Ignition Switch not in the "ON" position. 2. Engine Run Switch in the "OFF" position. 3. Discharged ...

Bike wont start, turn the key n everything lights up as normal, press the start button n just nothing Bike wont start, everything headlight, speedo n all management lights come on as normal, ...

When I turn off my XVS 1100 I get a heavy clonk as the engine kicks back any idea's Hi, Janet you may have a little pre-ignition going on you may want to retard your ignition timing 3-5 degrees and ...