Questions & Answers for: nec projector status light blinking red

...Projector does not start! There are different rates at which the status light will blink to indicate various errors. See manual (link below) page 49 ...

...nec VT676 model I use this projector as a projector for my SmartBoard and when i press the power on button, the power light goes green, then the status button goes green, then it blinks 6 times red 6 ...

Projector gets power, when first turned on power & status light are green. Then to goes into stand by mode power goes to blinking orange, status goes blinking red ( fast blinking) & it shuts off. this

...projector, the status light first blinks green a few times, then a beep beep beep is heard and the status indicator starts blinking red, 5 cycle: the manual says lamp failure, "wait a full minute and ...

...NEC VT 595 projector which wont turn on. It has a red blinking light. I changed the lamp but it has not changed the status. I had this same problem with 2 NEC VT595 projectors. My problem was that ...

status lamp blinking orange 6 times PROJECTOR. NEC VT491 THE STATUS LIGHT IS BLINKING 6 TIMES RED, AND THE POWER LIGHT IS ORANGE

Nec Lt245 power light yellow - orange status blink red, no image, no light coming out of the projector - Unplug the projector for a full 4-5 minutes. - Plug it back in and wait for the ready light and

...NEC VT45 projector. Would not POWER ON. LAMP was replaced with a new one the power supply on that model seem to go bad after a while. the caps aren't properly reted it's power needs. they dry up. if ...

Status light blinks red bulb replaced only 2 months ago Status light blinks red bulb replaced only two months ago? when i turn the power off and on the status light goes green for about 30 secs then ...

...NEC technical support, if the status light flashes red six times, this could indicate a defective lamp. If a new lamp is installed and the project still won't turn on, the projector will need ...