Questions & Answers for: needle hook

is done with the needle bar and hook and needle clearance (the distance between the needle and hook) which should be about .030. I'm a Bernina tech but many machines work the same principle. Good luck

...needle the hook is too far left - or close to the needle. It's adjustable by loosening the set screw at the base of the hook and by gently tapping the hook away from the needle. You want the hook to ...

...hook passes the needle, it should pass the needle slightly above the eye of the needle. If the timing looks good, use some alcohol on a bit of cloth to clean the hook, careful around the tip of the ...

...hook on the automatic needle threader (ANT) can get slightly bent to one side or the other by the needle passing to one side of the hook instead of the hook going through the hole and thus slightly ...

...needle and hook interplay. unthread needle for this. the hook should be about 1/16 from needle before the needle starts to rise.. good luck on setting the timing i can't even do that. since its a ...

...hook is close to the needle before retightening the clamping crews , and final give it a few turns by hand to make sure the hook locates the same all the time and the hook is not catching the needle, ...

...Needle and the hook is wrong, when the needle is about to lift, set the hook to be about 3 degrees off the needle line. This position may need tweaking but is usually about right. Thread the needle ...

hook - Replace needle. Threader hook bent - Replace with new needle threader hook. Hope this helps. Read more from the link I attatched. Good luck & have a nice day! Automatic needle threader will

...needle hook timing is consistent across the makes place the needle in the full down position the hook should be just about at the eye of the needle so that as the needle starts to come back up the ...

...hook. Check the needle size: Make sure you are using the correct size needle for the fabric and thread you are using. If the needle is too small for the thread or fabric, it can cause the needle to ...