...needle and seat. If the needle is not seating then the gas flows past it. If the float has a pin-hole leak, then it will fill with gas and sink. On some bikes you can remove the carb bowl without ...
...needle and seat leaking by. What we know for sure is that it is flooding because the float isn't holding the needle and seat closed. Usually this is because the soft part of the needle has a worn, or ...
...& clean, replace needle & seat as needed. Most likely the needle is sticking in the seat. Sometimes you can clean the seat & needle, if problem persists, replace needle &
needle and seat looked fine so I raised the float a little. re installed and the problem remained.. went to sears and purchased a new needle and seat. The seat was a small green plug with a hole in it
...needle seat. remove the float bowl remove the float hinge pin and drop the float (Shake the float gently checking to make sure there is no internal fuel inside the float.) If there is fuel in the ...
Question about Power Products 5,550 Watt Portable Generator #30241
...run correctly. Briggs and Stratton model 100602-0025-B1 make sure you have right needle and seat and dont install seat upside down the ring on seat goes toward carb sounds like wrong needle and ...
Question about 200cc Full Size Four Wheeler ATV
...needle and seat out of a ymaha kodiak 400 Take the float bowl off the carb. Pull the pin that holds the float on. The needle is attached to the float. The needle just came out of the needle seat. The ...
Question about 200cc Full Size Four Wheeler ATV
seat, The needle and seat let the gas into the bottom of the carby and as the gas rises in the bottom of the carby the float rises as well pushing the needle up into the seat slowing the gas flow into
Question about 200cc Full Size Four Wheeler ATV
...needle seat can be damaged 3) Dirt/debris/foreign object caught in the needle seat can hold the needle open causing a syphon effect 4) Debris/foreign material in the fuel can be transferred to the ...
Question about 200cc Full Size Four Wheeler ATV
When I start sewing on my singer heritage 8768 the needle hits something and bends. It stopped auto threading too If the needle isn't fully seated then the threader will not work and the needle will ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions