Questions & Answers for: neon 2 timing start

...Neon shakes when I try to take off fast, like it feels like the engine is jumping. Usually happens around 20mph, i can prevent it usually by starting off slow Someone said it could be someone with a ...

...neon gauges Every time I start the engine, all the gauges (Temp, Tach, Speed, Fuel) go to 100%, 75%, 25%, 0, then they begin measuring their respective values simultaneously. It started doing this ...

...neon will not run, I am wondering if the engine is shot. It has 199000 miles and has been a good car. Any suggestions?? it could be, but first you might want to run a onboard dianostic. turn your key ...

...neon with about 100,000 miles. Timing belt was recently replaced 2 months ago. Recently the car has had issues starting...you can hear the engine turn over but it just won't start. After the car sits ...

...neon is pinking i've changed the fuel and the spark plugs, what might be causing this ? runs fine when idle and below 2 thousand revs. when putting foot down to over take or speed up starts to pink. ...

...neon starts then immediately dies. There are no engine lights on. When I gave it gas to try to keep it going it died again and now won't even start. What could be wrong? This has also happened before ...

...neon completly stalled out..i turned it completly off but it started back up..i did this 2 or 3 more times then it just completly died and wouldnt start up at all...it wants to but just wont? My neon ...

...neon turn the key to start. but the engine well not crank.put new starter new battery still will not crank check fuse relay all are plug in ob-2 nothing ck see if firing at plugs ck see if has fuel ...

Neon. they changed the water pump tried to start the car it won't start after many tries. Will this mess up the engine? Very likely the timing is off. As long as it's not too far off it's not going to

...neon 2.0 se i bought 4 computers and the did the same thing, 2 new cam and crank shaft sensor. so unplugged cam sensor and it started right up. so decided to check the magnetic adjuster. it was ...